Parabody Leg Press 5 Manuel d'utilisateur télécharger pdf (Page 6)

11−1/4"

FIGURE 2

STEP 2:

• SECURELY assemble the SECOND ARM (5) to the FRAME (1) using one 1/2 X 4-3/4” BOLT (12), one 3/4 X 4” SHAFT (15) and one

1/2” LOCK NUT (13). See FIGURE 2.

• SECURELY assemble the MAIN ARM (4) to the FRAME (1) using one 1/2 X 4-3/4” BOLT (12), one 3/4 X 4” SHAFT (15) and one 1/2”

LOCK NUT (13). See FIGURE 2. (NOTE: Make sure MAIN ARM is orientated correctly, top hole should be 11-1/4” from the top of arm

as shown in FIGURE 2.)

• NOTE: Follow STEP 2 for the assembly of the LEG PRESS to the CM3 and GS6 Gym System. If you have the GS1, GS2, GS4 or GS8

Gym Systems proceed to STEP 3.

• Proceed to to STEP 3.

• SECURELY assemble two 1-1/2 X 2 BUMPERS (16) to each side of the MAIN ARM (4) where the MAIN ARM (4) contacts the FRAME

(1) See FIGURE 2.

12 1/2 X 4-3/4”

For assembly to the CM3 and GS6 Gym System .

Make sure MAIN ARM

is orientated correctly

• NOTE: FLANGE BEARINGS SHOULD BE PRE-INSTALLED

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Pas de commentaire

Parabody Leg Press 5 Manuel d'utilisateur Page 6