Parabody GS2 Manuel d'utilisateur télécharger pdf (Page 19)

• Refer to cable ILLUSTRATION “A” on page 14 for cable routing while installing pulleys.

STEP 17:

• Secure end of LOW CABLE (21) using one 3/8 x 3-3/4” BOLT (30), one 3/8” FLAT WASHER (36) and one 3/8” LOCK NUT (34)

as shown in FIGURE 17

• Loosely assemble one 3-1/2” PULLEY (24) between the PULLEY PLATES (12) using one 3/8 X 1-3/4” BOLT (27), and one

3/8” LOCK NUT (34).

• Assemble one 3-1/2” PULLEY (24) between BASE PLATES (3) using one 3/8 X 3-3/4” BOLT (30), two 3/8 X 1” SPACERS

(43), one 3/8” LOCK NUT (34) and tighten securely.

• Tighten both 3-1/2” PULLEYS (24) located on PULLEY PLATES (12)

FIGURE 17

3/8 X 3-3/4”

3/8 X 1 -3/4”

345

1/2 1/2 1/2 1/2 1/2 1/2

3/8 X 3-3/4”

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Parabody GS2 Manuel d'utilisateur Page 19