Parabody 400101 Manuel d'utilisateur télécharger pdf (Page 15)

FIGURE 20

345

1/2 1/2 1/2 1/2 1/2 1/2

STEP 20

• Assemble two 3/4” THRUST WASHERS (68) and two PEC

CAMS (24) to the LEFT (20) & RIGHT (19) PEC ARMS, as

shown on FIGURE 20.

• Insert four 3/4” FLANGE BEARINGS (69) into the bushings

of the BEARING HOUSING (17).

• Insert the LEFT (20) & RIGHT (19) PEC ARMS through the

3/4” FLANGE BEARINGS (69) in the BEARING HOUSING

(17) on their respective side as shown, and secure them in place

with two 3/4” STARLOCK COLLARS (73).

• Slide two PEC DEC ROLLER PADS (32) onto the LEFT (20)

& RIGHT (19) PEC ARMS until the ROLLER PAD (32) is

flush with the bottom of the pec arms.

• (NOTE: If a lubricant is required coat the inside of the

ROLLER PAD (32) with rubbing alcohol or water. Also,

rotating the pad while pushing up will help ease assembly.)

• Securely assemble two 3/8” SPRING PIN ASSEMBLIES (71)

to the spring pin barrels of the PEC ARMS (19 & 20).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Pas de commentaire

Parabody 400101 Manuel d'utilisateur Page 15