Parabody 400101 Manuel d'utilisateur télécharger pdf (Page 26)

FIGURE

• Screw the threaded end of AB CABLE (91) ap-

proximately 3/4” into the end of the PULLEY

BRACKET (5) and tighten jam nut securely as

shown in FIGURE 38.

STEP 38

• If upon completion of assembly, the HEAD

PLATE (81) does not sit on top of the first

WEIGHT PLATE (74), push the HEAD PLATE

(81) down, insert the WEIGHT STACK PIN (57)

and perform several repetitions at the press sta-

tion. This will relax the cable system and prevent

the HEAD PLATE (81) from lifting up.

CABLE ADJUSTMENT

• If after completing previous step, the HEAD

PLATE (81) still does not sit on top of the first

WEIGHT PLATE (74) or if there is excess slack

in the cable system, adjust the threaded end of the

LAT CABLE (92) accordingly and retighten the

jam nut.

• If there is excess slack in the AB or PEC DEC

cable system, adjust the threaded end of the AB

CABLE (91) accordingly and retighten the jam

nut.

• IMPORTANT! Make sure the cables are running

in the grooves of all pulleys.

• If there is excess slack in the LEG CABLE, move

the PULLEY attached to the LEVER STOP (12)

down one hole.

• IMPORTANT! Retighten both jam nuts when

adjustment is completed.

• The following adjustments can be made to adjust

the cable tension:

For maximum performance, the HEAD PLATE

should should just barely sit on the top WEIGHT

PLATE and the UPPER FLOATING PULLEY

BRACKET should firmly contact the PLATE on the

TOP BOOM, and the LOWER FLOATING PULLEY

BRACKET should firmly contact the BASE.

1 2 ... 21 22 23 24 25 26 27

Pas de commentaire

Parabody 400101 Manuel d'utilisateur Page 26