Parabody 400101 Manuel d'utilisateur télécharger pdf (Page 9)

FIGURE 9

345

1/2 1/2 1/2 1/2 1/2 1/2

FIGURE 10

DETAIL 9

1/4” NUTS

PUSH/PULL

CABLE

SPRING PIN

ASSEMBLY

DO NOT OVERTIGHTEN!

Assemble the PUSH/PULL CABLE from the PRESS ARM (8) to the SPRING PIN HOUSING and to the L-BRACKET on the

RECEIVING TUBE (13) as shown on FIGURE 9 and DETAIL 9 using the following steps:

STEP 9

· Thread the first 1/4-28 IN. NUT to the bottom of the threaded end of the CABLE. Allow the other 1/4-28 IN. NUT to hang loose

on the exposed CABLE until the SPRING PIN ASSEMBLY is attached.

· Securely assemble the SPRING PIN ASSEMBLY to the

SPRING PIN BARREL. (!!! IMPORTANT !!! TIGHTEN

THE NUT OF THE SPRING PIN ASSEMBLY SE-

CURELY)

· Swing the PRESS ARM (8) up until the SPRING PIN of the

PUSH/PULL CABLE engages in one of the adjustment

holes.

· Thread the second 1/4-28 IN. NUT onto the threaded end of

the CABLE, and cinch the two 1/4-28 IN. NUTS around the

flat.

· Use the extra thread on the end of the CABLE to adjust out

slack. ( !!! DO NOT ADJUST OUT TO FAR !!! AL-

WAYS ALLOW SPRING PIN ASSEMBLY TO FULLY

ENGAGE)

STEP 10

• Securely tighten two 5/32” SET SCREWS (65) and insert

two 3 X 2” END CAPS (75) into the open ends of PRESS

ARM (8) as shown in FIGURE 10.

• Securely tighten two 5/32" SET SCREWS (65) and insert

two 2” SQ. END CAPS (76) into the open ends of PRESS

ARM LEVER (9) as shown in FIGURE 10.

• Securely tighten one 3/8 X 1” BOLT (35), one 3/8” WASHER

(51), and one 3/8” LOCKNUT (48) to the bottom of AD-

JUSTMENT SLIDE (6) as shown in FIGURE 10.

• Insert one 1-3/4” SQ. END CAP (77) into the end of AD-

JUSTMENT SLIDE (6) as shown in FIGURE 10.

3/8 X 1” 35

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Commentaires sur ces manuels

Pas de commentaire

Parabody 400101 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Sports et loisirs Parabody 400101